• Author / Uploaded
• extemporaneous

Citation preview

Ormus Derivation

~ ìì ã îî

Ormus Derivation (Or-mus [light-giver], Ormes [OrbitallyRearranged-Monatomic-Elements], The Spring of Eternal Life [The Fountain of Youth], Philosopher's Stone [Azoth], Monatomic Gold [White Gold], etc.) “God sleeps in the rock, dreams in the plant, awakens in the animal, and becomes self-aware in the human” – From the ancient Hindu Vedas. 1. 'Stir ½ cup (4oz) of organic sea salt, using a glass, wooden, or plastic utensil (no metal!), into a glass (or stainless, but no aluminum!) bowl, containing 2 cups (16 oz) of natural spring-mineral water (with magnesium). Let the solution sit dissolving for one hour (or longer, as necessary to reconstitute)'. 1.

2. 'Bring our solution up to a pH level of 10.78 °, by carefully and slowly adding approximately 4.5 oz of lye solution to a continuous stirring of our reconstituted sea-water, @ no more than 1 drop per 20 seconds, bringing our pH level slowly up to 10.78 °'. 3. 'Let our solution sit undisturbed in a dark, warm place, void of ultra-violet light and interference from magnetic fields, such as in a Faraday Cage, for 1 day'. 2.

4. 'After sitting for a day in the Faraday Cage, the substrate, or clear Gilcrest particles that will not precipitate above pH 10.78 °, will float on the top, while leaving the white precipitate at the bottom. Using a large syringe, turkey-baster, or siphon hose, remove and dispose of the clear ('waste') liquid that sits above, and save the m-state ('monatomic elements') that will be present in the white liquid (approximately 12 oz) formed below'. 5. 'Flush the m-state elements ('white slurry'), by adding clean water (12 oz) to our remaining precipitate and thoroughly stirring (without metal) the solution. Let settle for 12 hours. After sitting for 12 hours, again, discard the top layer'. 6. 'Continue flushing, by repeating step five (5), twice more'. 7. 'Take our remaining solution and add 12 oz of clean water. Using a bain-marie (double boiler), bring it to a gentle boil (212 °F) for 5 minutes (on a gas stove only!)'. 3.

8. 'At room temperature, bring our solution to a pH of 12.00 °, by slowly adding approximately 1.5 oz of our lye solution (or as much needed in raising our pH level up to the desired 12.00 °)'. 9. 'Once again, using the bain-marie, bring our solution to a boil for 5 minutes. At room temperature, our solution should be at a pH level of 12.00 °'. 10. 'Filter our solution (using coffee filters and a funnel), leaving only a clear liquid of dissolved mstate elements. Check our clear filtrate pH level. It should not have gone lower than 11.5 ° after filtration'. 11. 'Slowly bring our clear filtrate down to a pH level of 10.78 °, by slowly stirring in (without metal) CHl, or distilled white vinegar. When the mstate solution has congealed, it is ready for use'.

4.