• Author / Uploaded
• Syafiq Hazmie

Citation preview

JETPLUS INSTRUCTIONS PART I >CONSTRUCTION Example model: Arcturus Cut out and prepare the parts according to the guides on the template. Use the picture on the left to help you. I went over some areas of my parts with a black permanent marker so that the white edges of the paper don’t show in the finished toy.

1

Glue the arms to the body as shown. You may want to use tape to reinforce the bond. Seal the body, leaving the top flaps open.

2

3

4

2nd 3rd

1st

Insert the top of the chest piece into the body as shown. Glue and close the flaps in the order shown. Make sure not to get glue on the chest piece. You should be able to move the chest in and out of the body without having it come off.

JETPLUS INSTRUCTIONS PART II >CONSTRUCTION 5

6

Glue the belt piece to the body. Tuck the chest piece into the belt as shown.

7

8

9

Glue the legs to the belt piece. Take your time to do this. I would reccomend that you glue one leg first and wait for it to dry before proceeding to the next one. After both legs are done, push the flaps on the legs into the slot at the bottom of the body.

10

Glue the wings to the back of the toy, making sure that it lines up with the horns. Done!

STEP 1

JETPLUS INSTRUCTIONS PART III >TRANSFORMATION

STEP 2

Split the legs, pulling the flaps out of the slot at the bottom of the body. Tuck the arms all the way into the slots at each leg. Fold or curl the arms if you have trouble doing this.

STEP 3

Remove the chest piece from the belt and then push it into the body.

Push the horns into the slots at the chest. Done!