• Author / Uploaded
• ZulHafiz

Citation preview

PTS 15.20.03 PROTECTIVE COATINGS AND LININGS

February 2016 Page 97 of 112

APPENDIX 13: COATING DAILY INSPECTION REPORT TEMPLATE COATING - DAILY INSPECTION REPORT Do not leave empty boxes. If Not Applicable please enter N/A CONTRACTOR WORK LOCATION PROJECT/ITEM TITLE CONTRACT NO. WEATHER CONDITIONS

COATING SYSTEM NO. REPORT REF. NO. ITEMS COATED DATE

Time / Date Rel. Humidity (%) Dewpoint ( C) Metal Temp. ( C) SURFACE CONDITION AND DEGREASING (Circle/Highlight as necessary) Original Status Metal Condition Metal Rust Grade ^^ Coating Breakdown ## Contamination Degreasing Agent

Coated Defect-free A Ri 0 / 10 Heavy …………………….

Wrapped Laminated/Pitted B Ri 3 / 6 Light Swabbed

Bare Ground C Ri 4 / 4

Rejected D Ri 5 / 1

Sprayed

Water Tested

SURFACE PREPARATION (Circle/Highlight as necessary) *= ISO 8501-1 Method Dry Blasting Sweep Blasting Wet Blasting Power Tool Hand Tool Abrasive Used Type………………. Brand………………. Batch No…………... Size Range……….. Prep. Standard SSPC SP 5/*Sa 3 SSPC SP 10/*Sa 2.5 SSPC SP 7/*Sa 1 SSPC SP 3/*St 3 Other…………. Profile Ht. (um) 35-50 50-75 75-100 Range………... Using…………. Other Tests Salts…..…. Yes/No COATING APPLICATION (Circle/Highlight as necessary) Method Airless Spray Air Spray Brush When Priming Time Since Cleaning………………….. Product Details Product Base Batch Additive Thinner # and No. Batch No. percentage Stripe Coat Primer First Midcoat

Trowel Other…………. Visible Surface Rusting…..……….Yes/No Overcoating WFT Range DFT Range Period (um) (um)

Second Midcoat

Topcoat FINAL TESTING AND REPAIR (Circle/Highlight as necessary) Thickness/Appearance DFT - Accept/Reject Holiday Detection Test LV/HV Tester ………… Coating Adhesion Test Adhesion Tester……… Repaired Areas % of Total Area………..

Test Voltage…………….. Pull Off Stress…………… Primary Locations……….

Appearance - Accept/Reject Pass/Fail Accept/Reject Rejected Because……….

T.P.I. ( If Applicable)

OWNER

GENERAL COMMENTS: CONTRACTOR Signature Name Position Date ## CORRESPONDING DEGREES OF COATING RUSTING STANDARDS(ISO 4628-3 / SSPC Vis. 2): Ri 0/10- No visible rusting of coating; Ri 3/6- Marked localised rusting of 1% of surface area; Ri 4/4- Widespread localised rusting of 10% surface area (8% for Ri.4); Ri 5/1- Extensive rusting of up to 50% of surface area ^^ Bare Metal Rust Grade standard according to Visual Standard SSPC-Vis 3